alan tani @ alantani.com fishing reel repair rebuild tutorial LX 4.1 rebuild
Fishing Reel Repair by Alan Tani
May 24, 2013, 09:19:23 AM *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
 
   Home   Help Search Login Register  
Fishing Reel Repair by Alan Tani > Reel Rebuild Tutorials and Questions > Avet Tutorials and Questions > Topic: LX 4.1 rebuild
Pages: [1]   Go Down
« previous next »
  Print  
Author Topic: LX 4.1 rebuild  (Read 898 times)
0 Members and 1 Guest are viewing this topic.
Bp919
Member
*
Offline Offline

Posts: 4
« on: January 09, 2011, 07:00:43 PM »
Alan et al ... Just picked up an older LX 4.1 in pretty good shape, did the regular rebuild ( clean up, greased drag, spool bearing oil, etc.) and came out well - good free spool, very smooth drag, can get 15#'s at strike...The only problem I ran across was that at that rated drag setting (15#), the preset knob bottoms out. Drag is ok for now, but I'm worried that after a few runs, I'll run out of room on the drag... Any suggestions?... Can I add a bellville or 2 to the stack? Current set up is six washers in the ()()() configuration... I like the reel, also would be great to get a few more #'s of drag @strike....any ideas would be very welcome.... Thanks
Logged
alantani
admin
Administrator
Member
*****
Online Online

Posts: 7846
« Reply #1 on: January 09, 2011, 08:23:03 PM »
add a flat washer or another belleville next to the belleville stack already in place.  if you want me to mail you a couple, send me a pm with your address.  alan
Logged
for questions, send an e-mail to alantani@yahoo.com
Pages: [1]   Go Up
  Print  
Fishing Reel Repair by Alan Tani > Reel Rebuild Tutorials and Questions > Avet Tutorials and Questions > Topic: LX 4.1 rebuild
 « previous next »
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.089 seconds with 15 queries.