Accusleeves DYI dimensions

[JGB]

Here are the machining dimentions for the Accusleeves we have details on:
Dimensions are in inches and should be cut to +/- 0.001" for best performance.

Accurate Sleeve   length   OD
      
      
Platinum TD 50      1.701   0.393
Platinum TD 30      1.607   0.353
Platinum TD 12      1.469   0.353
Platinum TD 6        0.880   0.353
      
Boss 870              1.150   0.218
Boss 665 HW        1.672   0.218
Boss 665 H           1.245   0.218
Boss 270              0.957   0.218
Boss 197              0.441   0.218

Have fun
Jim N.

[Bryan Young]

Hi Jim,

Do you have the ID or the shaft's OD?

I ment to call, but having a busy week.  Will probably be at Alan's tomorrow afternoon.  Will call tomorrow for sure.

Bryan

[Comedie]

Boss 665H Narrow,,,, measured .961, final sleeve .968.

Spool alone with inside micrometer measured exactly the same as my Boss 270. Needed a slightly longer sleeve on my particular spool, however, since one bearing counterbore seems to not be straight to the bottom. So instead of outside micrometer measurement I did it a bit uglier way using a depth micrometer down the inside to the back of the 'seated' bearing.