Shimano Speedmaster IV part

Started by SamCar, September 28, 2016, 04:27:19 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

SamCar

Hey guys,  I have a Speedmaster IV that I need a part for and it is obsolete.  It is TGT0109 a lock washer that goes under the screw that holds the gear lever in place.  Mine must have rattled off on the last trip and is now MIA.  Can someone take a picture and measuements of this washer so I can reinstall a new lever?  Thanks!
Lose one rig one. -Capt. Quint

alantani

#1
i checked and i do not have one, but a standard metric lock washer should do.  it would have to be stainless steel.  i found these at http://www.mcmaster.com/#standard-washers/=14d78pa

Metric External-Tooth Lock Washers

Teeth on the outside edge of the washer bite into the screw head and joint for a tight grip. Use with fasteners that have heads large enough to make contact with the teeth, such as pan, button, and binding head screws.

18-8 stainless steel washers have good chemical resistance and may be mildly magnetic.

For technical drawings and 3-D models, click on a part number.For technical drawings and 3-D models, click on a part number.
For Screw
Size   ID,
mm   OD,
mm   Thick.,
mm   Specifications
Met   Pkg.
Qty.       Pkg.
18-8 Stainless Steel
M3   3.2   6.0   0.3-0.5   DIN 6797   100   95060A320   $2.75
M4   4.3   8.0   0.4-0.6   DIN 6797   100   95060A330   3.00
M5   5.3   10.0   0.5-0.7   DIN 6797   100   95060A350   3.66
M6   6.4   11.0   0.6-0.8   DIN 6797   100   95060A360   3.82
M8   8.4   15.0   0.7-0.9   DIN 6797   100   95060A390   6.97
M10   10.5   18.0   0.8-1.0   DIN 6797   100   95060A400   7.57
M12   13.0   20.5   0.9-1.2   DIN 6797   50   95060A411   7.08
M14   15.0   24.0   0.9-1.2   DIN 6797   50   95060A420   10.01
M18   19.0   30.0   1.2-1.6   DIN 6797   10   95060A440   5.89
M20   21.0   33.0   1.2-1.6   DIN 6797   10   95060A450   6.27
send me an email at alantani@yahoo.com for questions!