alan tani @ fishing reel repair rebuild tutorial tyrnos problems
Reel Repair by Alan Tani
December 19, 2018, 04:12:07 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
   Home   Help Search Login Register  
Pages: 1 [2]   Go Down
Author Topic: tyrnos problems  (Read 1841 times)
0 Members and 1 Guest are viewing this topic.
Online Online

Posts: 3265

OCD Reel Service and Repair

« Reply #15 on: November 22, 2017, 02:42:25 PM »

Bryan its 2 piece. It also has the 2 pins that key the main gear and anti reverse ratchet together. I still think the problem is in that area. My second thought is the pinion gear slipping in the drag plate.

I assume he made sure the handle arm isn’t slipping on the main shaft.

OCD Reel Service & Repair
Gulf Breeze, FL
Firearms Group
Offline Offline

Posts: 197

« Reply #16 on: November 25, 2017, 09:52:53 AM »

Remember the crumbly, crappy drag these came with? Change that out to carbon fiber w/cals grease. Low drag pressure usually feels rough, like in the first video. Try putting some real pressure on a new drag and see what happens.

That what i would recommend too.

After short time the original drag washer looks like an old carpet.....

For to get higher drag you can add an additional belleville. Based on TYR-30II can recomm configuration (((()
You have to remove one or two of the Thrust Washers! Figure out best for your reel. Do not know about which size we are talking.

Good Luck

* tyr_1.png (109.63 KB, 258x270 - viewed 198 times.)

* tyr_2.png (78.49 KB, 322x200 - viewed 203 times.)
« Last Edit: November 25, 2017, 09:55:19 AM by Wolli » Logged

love jigging
Authorized Jigging Master Service Partner (in Germany)
Offline Offline

Posts: 7

« Reply #17 on: December 17, 2017, 11:54:45 AM »

Just a stab here. Maybe try to tighten TGT1186 DRIVE SHAFT SCREW. I just serviced one of these reels and had read somewhere that this nut will come loose and the handle may fall off or slip. I checked mine and got a 1/4 turn on it. If it was loose could it slip from the gear there?
Firearms Group
Offline Offline

Posts: 839

« Reply #18 on: January 12, 2018, 05:43:37 PM »

I think Bryan and Keith have pinpointed the trouble spot for you.

Either the pinion guard teeth may be worn OR too much or too sticky a grease is causing the pinion gear to the shaft and bearing.
Have you tried it with just a thin layer of grease or thinning your grease with some corrosionX.

Good luck
Offline Offline

Posts: 979

« Reply #19 on: January 12, 2018, 07:18:43 PM »

My best guess is it's missing a piece or something was put in backwards, etc. I'm going with spacing issue.

Second guess would be corrosion inside the spool.

I don't see how the pinon bearing would cause that. A dead pinon bearing can feel okay in your fingers but will sound like a coffee grinder when the drag is engaged. A bearing that is that totally dead will be bleeding rust and will barely turn.

Pages: 1 [2]   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines
Simple Audio Video Embedder
Valid XHTML 1.0! Valid CSS!
Page created in 0.2 seconds with 18 queries.