Magnetic Bearing Puller

[BassMatt]

I have posted this subject before in another post, but then realized it should have been in another post by itself.
The question I have is has anyone thought about using a magnet pickup tool to pull a bearing from a side plate or similar socket that might require a tool or something to pull or remove it???

The plus to this idea is to remove a part without risk of scratching or bending precision parts.
On a bearing, it pulls with uniform pull on both races at the same time.

It’s been said and could easy happen that the down side to this is it may cause the part to become magnetized, which could attract unwanted metal wear debris or pieces, but I observed something interesting tonight as I was installing my new cleaned bearings in my side plate socket on my reel. As it set in the socket, the ball bearings moved a little with rotation. Then I realized, my magnetic spool brake was pulling it.

So is having a magnetic brake on the reel bad for bearings? If not, are there any other cons to using a magnet tool to pick small parts? (Other than off the floor of the parts you dropped)

I been using a small magnetic tool to pick bearings on my reels for two years now and never have had any issues. What are any of your thoughts, pros or cons?

[inhotpursuit]

I would be carefull you might magnetise the bearing races and the ball bearings that might slow it down,otherwise i don't see a problem

[alantani]

maybe try it, but if can't pop it out easily with a small puller, chances are it will not come out with a magnet.   

[Brendan]

I have done it, but never again. One of my reels slowed down a lot and when I pulled the bearing and spun it, once it stopped it actually changed direction. IMO it became magnetized. Maybe no, but I am contacting reelspeed for bearing pullers.
Brendan.

[HalBrown]

My primary bearing puller is the bent end of a large bobby pin.  It is coated and works.

[bluefish69]

I use a Dental Pick on the Newell Bearing Caps

[Makule]

I have done it, but never again. One of my reels slowed down a lot and when I pulled the bearing and spun it, once it stopped it actually changed direction. IMO it became magnetized. Maybe no, but I am contacting reelspeed for bearing pullers.
Brendan.

Another method for cast control, perhaps?

[Brendan]

     All I know is it slowed the free spool time down a lot and I'm scared to ever do it again. The whole reason I go through all of my reel routine is to gain casting range since I sit shotgun on most of my fishing trips. I have spent a lot of time and money on bearing upgrades, and want to see constant improvement on free spool time. I feel that I lost some bearings using that technique.
     Just my .02 worth, Brendan.

[Jimmer]

I think most people with some mechanical training consider magnetizing a bearing to be poor practice. Maybe JGB would commment her, his opinions are highly respectd. - Jimmmer

[Pro Reel]

Quite ofren, a bearing will get magnetized from cleaning it in an ultrasonic cleaner. Simply pass it through a tool demagnetizor or pass it through the flame of a lighter for a few seconds and the heat will demag it.

[Jimmer]

Holding a bearing with pliers and moving it at different angles through the loop of a plugged in soldering iron will demagnetize as well.

[redsetta]

Great advice Kevin/Jimmer - cheers.

[wallacewt]

x2. every day something new.