New Guy with Penn International 30 Problem

[UKChris]

I know this is a bit of an old thread, but when playing about with an old Int 30 I managed to re-create the same problem that Rwade27 had. The cure was to replace the small shim I had left out of the stack of Bellville washers just to see whether it made any difference - it did.

()() and I had rubbing and no freespool until moving the drag lever up a little bit, but ()|() and all is well.

[steelfish]

I know this is a bit of an old thread, but when playing about with an old Int 30 I managed to re-create the same problem that Rwade27 had. The cure was to replace the small shim I had left out of the stack of Bellville washers just to see whether it made any difference - it did.

()() and I had rubbing and no freespool until moving the drag lever up a little bit, but ()|() and all is well.

old thread but thats a nice tip for international users