3/0 bearings

Started by mikeg24thst, April 13, 2015, 06:43:45 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

mikeg24thst

April 13, 2015, 06:43:45 PM
Do you make or has anyone tried to make 3/0 bearings

alantani

#1
April 13, 2015, 10:20:45 PM
no, there is only room for bushings, but they work pretty well once you polish them out.  don't forget to polish out the inside of the pinion gear and the spool shaft.  that's where most of the resistance occurs. 
send me an email at alantani@yahoo.com for questions!

Alto Mare

#2
April 13, 2015, 10:24:09 PM
Accurate plates...if you can find them.
I might be getting stainless steel plates for the Jigmaster, if those happen I don't see why the 3/0 wouldn't happen as well.Those will be expensive though :-\
Forget about all the reasons why something may not work. You only need to find one good reason why it will.
Print
Go Up Pages1
User actions