113H with a not very deep slot for the eared washer

Started by Bryan Young, April 25, 2016, 03:34:21 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

Bryan Young

April 25, 2016, 03:34:21 AM
I cannot find the posting, so if you are the one with an original 3- stack Thant would like to convert to a 5 stack or 7-stack, I may have a solution by mixing in some of my metal drag washers with 0.5 mm thick Carbontex washers that I have cut. Please let me know who you are and when time permits, I will post the washers and sequence.

Bryan
:D I talk with every part I send out and each reel I repair so that they perform at the top of their game. :D

Long Enuff

#1
April 25, 2016, 11:10:44 AM
Not my post Bryan, but I had the same issue with an older 114H.  I simply used one of the original 3 stack metal keyed washers, which was much thicker than the 5 stack washers, as the first keyed washer in the sequence.  That raised the bottom of the stack enough for the slot to grab the first eared washer.

Bill
Print
Go Up Pages1
User actions