Luvias 2510PE-H Drag Set

[exp2000]

I just got a 2015? Luvias in and the felt drag washers were completely disintegrated.

I might try chopping some carbontex but I need a reference.

Don't suppose anyone has dimensions for these?
~

[Tiddlerbasher]

If you don't get a knowledgeable reply - I would just measure the drag chamber diameter and spool shaft - cut/punch to fit. Some of the Daiwa reels used .5mm washers most spinners use 1mm. I would start with 1mm cf - if you can't fit the whole drag stack swap to .5mm or .7mm - all it has cost is a bit of time. Do you get your cf sheets from the downriggershop.au? My last couple of sheets came from them - cheaper than from the US.

[exp2000]

Do you get your cf sheets from the downriggershop.au? My last couple of sheets came from them - cheaper than from the US.

I think I bought a sheet from them once but the safest bet is to buy the original carbontex sheets from Dawn at smooth drag.

Some people have experienced bad results buying from eBay suppliers.
~