Good Afternoon to ALL today!
I am servicing a customers 7500 and 8500 SSV.
The pinion bearings have what I must call a very rare rest of measurements.
I am getting OD 18mm, ID 10mm, Width 5mm
its the width measurement thats a pain.
I went to my local bearing store, and they can't find it. BOCA doesn't have it either and another bearing place. I can buy from PENN but I usually get good prices at the local store. This is really odd coming from a PENN Reel.
Any tips or advice?
I have some in the shop. I will get the measurements tomorrow afternoon.
Keith
Quote from: handi2 on April 17, 2019, 10:38:34 PM
I have some in the shop. I will get the measurements tomorrow afternoon.
Keith
Sounds good Keith
Thanks
You sourced them from Penn or your bearing store?
My Fin Nor Offshore line roller bearing even rare
ID 5.5mm, OD 7.5mm & Width 6mm. Can't even find in my local bearing shops or any one-line shops. Just force me to order from Fin Nor Service Center >:( >:( >:(
Quote from: Pierce on April 23, 2019, 11:04:09 AM
My Fin Nor Offshore line roller bearing even rare
ID 5.5mm, OD 7.5mm & Width 6mm. Can't even find in my local bearing shops or any one-line shops. Just force me to order from Fin Nor Service Center >:( >:( >:(
Yea I don't get that. I ended up ordering from mystic parts which is fine, but usually my local bearing supplier carries my bearing needs. This was an experience.
I had them on my table today. I will measure them again tomorrow.