Print Page - Daiwa Sealine 350

Title: Daiwa Sealine 350
Post by: ericjp on September 14, 2009, 05:03:51 PM

Alan,

Do you know if the drag washers are the same as the 400\450? I've looked through the schematics from Daiwa and can't tell. The drag washers look like the ones in your tutorial.

Thanks,

Eric

Title: Re: Daiwa Sealine 350
Post by: alantani on September 15, 2009, 03:30:47 PM

you know, i don't. i don't have a 350 in line, either. can you pull the drag washers and measure them? i'm sure we can match them up to something. alan

Title: Re: Daiwa Sealine 350
Post by: ericjp on September 16, 2009, 12:22:01 AM

I could only find a ruler to measure them. The outside diameter is 24mm, inside 14mm, 1.3mm thick? There is a lot of space between the drag washers and gear sleeve. I gear sleeve is 13mm. Do you think these would fit? #6-875 ($1.25) / 13.06 x 25.01 x 1.23 / 875 line counter, or would it be better to try to find one with a 15mm inside diameter?

Thanks,

Eric

Title: Re: Daiwa Sealine 350
Post by: alantani on September 24, 2009, 03:37:43 AM

it is the outside diameter that is important. sounds like you've got the right one. alan

Title: Re: Daiwa Sealine 350
Post by: ericjp on October 17, 2009, 11:49:44 PM

I ended up using the washers for the penn 114. Perfect fit!

Title: Re: Daiwa Sealine 350
Post by: alantani on October 19, 2009, 04:32:43 AM

a #6-114! that's great! i'll bet a #6-855 will fit underneath the main gear. alan

Reel Repair by Alan Tani

Conventional and Bait Casting Reel Rebuild Tutorials and Questions => Daiwa Tutorials and Questions => Topic started by: ericjp on September 14, 2009, 05:03:51 PM