Can anyone help me find a Anti-reverse roller bearing for the for GrandwaveZ 20, maybe the part dimensions of this? Having some difficulty find this part for the reel.
Thanks.
i have all of the common sizes. they measure in millimeters - inside diameter, height and outside diameter. cheap digital calipers are very helpful.
Have you tried calling Daiwa?
(800) 736-4653
Thanks for the replies.
I did call Daiwa, but they did not know the bearing diameter.
Any suggestions on how to remove this anti reverse bearing from the reel?
I was reading somewhere to use a 10 mm socket?
usually they just tap out, well supported underneath to avoid damage to the side plate, but it's best if i could see a photo.
Sorry about the delay, was a busy Sat for me. Did an oil change and had to get family stuff ready.
I got the bearing out of the reel, now the issue is, removing the bearing from the plastic around it? Is this possible?
Also, I got the approx measurements with my calipers.
Approx:
1 CM inner diameter=10 mm
1.3 CM outer diameter=13 mm
Width, can't measure due to plastic in the way.
Quote from: wussero on October 18, 2020, 04:17:30 PM
I got the bearing out of the reel, now the issue is, removing the bearing from the plastic around it? Is this possible?
the AR bearing gently presses out. it's an EWC 10 something. i think the plastic case was supposed to stay put...... :-\
Lol,
I did that. I guess there is not much more than I can do?
Replace the roller bearing and cage in parts?
Good news!
I cleaned out the grease within the anti reverse bearing, then I just small dabs so the little metal feet for the rollers would fit. That fixed the anti reverse issue. Whew! All working now.