So I was tearing down a few Penn's this week and got to thinking that I dont remember seeing anything about stock drags and how many pounds of drag could be expected for the 113H or the GLS 25.
Also when measuring drag - does it make a difference whether the line on the spool is full, half, or barely loaded with mono?
Thanks
i dont know the drag setting's for those reels but when a reel is full it takes less effort to pull out line, as the spools emptys the drag pressure increases. the drag force will be doubled when approximately 75% of the full spool is off the reel. hope this helps aloha
kamu
with the line at the top of the spool, figure 15 pounds for a 113h. a hotrodded gls 25 would be about the same.
Here is a dumb question - what is a hotrodded reel Alan?
getting more drag by adding belleville washers.()() = soft ((())=a little more drag and finally full on hot rod((((( you need to mic out your exsiting stack and add bellevilles to get the same stack height. then for casting alan always recomends cleaning out all grease and lube for casting distances. as for lube he has been trying all kinds of stuff you can find it here on his site