I've cleaned, replaced bearings and drag washers and am now in the process of reassembling my201 sg...my problem is that I can't figure out where the anchor points are for the retraction springs on the push button soil release...the on line schematics are too fuzzy to give me a real good image as to attachment...any body know what I need to know?
The Bantam 100 looks like this, but from the schematic the 210 has flat springs instead of coil springs. This schematic has lines showing where the little spurs are on the release bar.
http://www.reelschematic.com/wp-content/uploads/schematics/Shimano/Bantam/SHIMANO%20BANTAM%20201SG(1982).pdf (http://www.reelschematic.com/wp-content/uploads/schematics/Shimano/Bantam/SHIMANO%20BANTAM%20201SG(1982).pdf)
(http://www.raingarden.us/snap/Bantam100(f).jpg)
-steve