After servicing the squidder, jigmaster, and surfmaster, I have to say my least favorite to service is the squidder because of that darn dog spring it uses. I was able to trim down a jigmaster spring to use in a squidder, but man that took forever and I lost a few springs in the process. Any tips on how to install the dog spring? Also is there anywhere I can get some squidder sized springs so I don't have to trim the jigmaster ones again?
Springs #108 & #14, are available at Scott's -- on our site -- for a few cents...
One is factory -- one is a work-around -- but works fine.
I have these also -- but Scott's is in the business -- and I don't want to send you the wrong one.
Best,
Fred
PennParts now have springs that are direct replacements for Stock springs.
Thanks for the info guys! When I ordered a bunch of parts from scotts about a year ago they did not have these direct replacement springs.
They just got them a few months ago. It's hard to find springs that small.
I have problems getting them over the posts also. The last one I did slid the ringed end of the spring that goes over the post onto a ice pick to stretch it a little seems like there must be a better way. Anybody have a trick ?
I hold the spring over the post with a finger while use a pick to push and slide it over the post. Now always effective, but I do finally get it on the nth try. Where n= 2-😭