If anyone got lug blanks like the ones below send them back and I will fix them. I do not have reading glasses and missed a few.
(http://i1101.photobucket.com/albums/g431/pescatore1/20160526_231116.jpg)
What's up with them?
I haven't had a chance to check mine yet.
Some were not cleaned up all of the way, from left to right, good, a little missed, good, more missed, a little missed, good, a lot missed, a little missed. It is a small piece not cut to keep part from falling into the tank.
Lee, I rubbed them on a sheet of 2000 wet-r-dry for a couple minutes and they were fine.
If this was an issue that the lugs needed to be sanded a little more, I would have done it and never contact Lee.
Unfortunately the marks are deep enough that if you sand them down clean, the lugs would sit below the plate lip.
The pic above is mine, I contacted Lee this morning, not to complain, but simply to ask if all other look the same.
Lee was willing to replace them, but I told him not to, I'm ok with those as they are, I was just asking a question.
The man does some amazing parts for us, any feedback, good or bad will make it that much better.
Sal
Looked mine over and nothing a little 1200 grit won't cure, I'm keeping them.
Yeah, I'm going to need a couple more sets Lee.
Quote from: Keta on May 28, 2016, 12:35:54 PM
If anyone got lug blanks like the ones below send them back and I will fix them. I do not have reading glasses and missed a few.
Recall ?? LMAO
Lee, I do not have reading glasses either, and they look perfect to me :D :D You want em back, you're gonna hafta pay triple, cause I'm keeping mine
Im keeping mine too
Clarifying....
I felt I needed to mention the marks on lugs, Lee always appreciates my input.
I never asked Lee to have a recall on those, or post my pic, this was his decision.
As stated above, I'm ok with mine.
Sal
I need input and want my parts to be the best I can make, it was my call to post this when I saw substandard work. If I did not post this it would bother me every time I thought about it.
You're a good man lee, but everyone else already know it.
Just to reinforce what has already been said. Lee does some amazing work. Most all his pieces are done by hand and he is very meticulous. The Man has some skills and takes pride in his work. It shows in every part I get from him.
Lee, You are a Class act my friend. ;)
Quote from: Shark Hunter on May 29, 2016, 05:50:17 PM
Just to reinforce what has already been said. Lee does some amazing work. Most all his pieces are done by hand and he is very meticulous. The Man has some skills and takes pride in his work. It shows in every part I get from him.
Lee, You are a Class act my friend. ;)
Can I get an AMEN!! ;D
Amen. 8)
Lee has been nothing but good to me. Generous to a fault.
If I was building stuff for the display shelf I might ask Lee what I need to do, but my focus is going to be getting all my reels ready for use. I'm going fishing.
Completely satisfied with the lugs.
Thanks Lee.
I don't even have the parts, but laud the backing and professionalism of everyone involved. You can't beat AT.
Lee, I was organizing some pictures today on Photobucket and looks like the one above got moved.
Let me know if you need it and I'll try to find it.
Sal