Does anyone have a schematic for this reel?
The spool is knocking at the bottom of the stroke inside the rotor.
I think there is a washer/spacer missing.
Thank You
-Steve
search the model on this forum -- it's been done ;D could be under Compac Atlas III(?)
also sold as a Dimond and Pflueger... all OEM by Omori/Ohmori
four chances at a schematic, LOL
It is comparable to the Pflueger 640 II. There are no shims between the bearing retainer and rotor. The 640 II schematic shows 2 washers between the spindle and spool. Maybe your spindle isn't seated deep enough or just needs some shim adjustments.
Don't know if this will help any.
Frank
Thank You Frank
That will help when I get around to doing a full rebuild.
Tommy
Thank You for the tips.
There was a metal washer/shim under the rotor.
I removed it and the knocking is gone.
There was only a red fibre washer under the spool.
The metal washer that was under the rotor is too small to
fit under the spool. Maybe when I rebuild the reel I'll figure out where it belongs.
Now I have a washer missing from under the spool.
What problems might that cause down the road?
Thank You
-Steve
this may help
www.planetseafishing.com/reel-schematics/shakespeare-models/
Quote from: Wolli on December 04, 2020, 01:08:49 AM
this may help
www.planetseafishing.com/reel-schematics/shakespeare-models/
All those listed are either Sigmas or skirted spool models. No help for the 2200 II, but here it is (below).
Also, there is supposed to be a thin bushing/washer between the ridge on the pinion and the bearing. Is it possible that your extra shim washer is to go there?