tom made this for me a while back, but i'm finally getting around to posting the installation tutorial. we've eliminated the need to drill, but actually bolting the handle on has proven to be a little more tedious than intended. we want to get rid of the oval grip and bolt on something a little larger. basically, you remove the old rubber grip and you're are left with the arm and a stainless steel post. no more drilling.
for tools, you will need a size "O" phillips, a dental pick, a quarter inch driver extension, and a flat driver bit.
back out the two small screws and remove the handle cap.
you'll see a tiny hex nut. to remove this, use the 1/4" drive extension. it's a perfect fit!
the oval knob will lift right off.
but, wait, there's more! inside the knob are more washers. beneath the hex nut is a lock washer, then a "D-shaft" washer, and then three flat washers.
for those of you not familiar with D-shaft washers, they are designed to fit on a shaft with a matching cut out. you can see it here.
slide on the new handle, then two of the flat washers, and finally the D-shaft washer.
now install the new screw cap. if you're lucky, you are done. ok, it's too tight? remove a flat washer. too loose? add a washer. generally, two washers works.
you will have these left over parts. save them. you never know.....
your new handle is ready to enjoy. they are $35 each plus shipping!
thanks! alan
The install was easy when I put one on my JX.
I have one of those handles on my HX Raptor. It's great! I kept the original egg knob on my JX's since I use them for yoyoing and the egg works well for fast turning of the handle and the HXW Raptor already has a nice power handle.
Quote from: CooldadE on August 12, 2022, 05:07:33 PMCost and availability ? What size 3/0 or 5/0 ?
only in the 5/0 size. they are $35 plus shipping. figure about $4 for first class mail.
I put this handle on my reel. It came off of the wide reel.
Mike