Was giving a little TLC to my 235 and during re assembly the head popped off on one of these screws. Fortunately there was enough of the shank protruding to easily remove it from the spacer bar. Problem now is a replacement. Does anyone have one of these they are willing to part with?
Thanks- John
PM sent
This looks like a standard screw, has anyone sourced McMaster for these?
The size is 5-40 x 3/4 or 1/2 depending on the side. McMaster has them by the box cheap.
Could you possibly send me the link to McMaster for these screws because they have them in phillips, but not in slotted, oval head.
Searched the internet for the 3/4", and could only come up with 5/8". There was one site that had 1", and worst case I'd have to cut off a quarter inch.
Hi wahoo --
If you still need one -- got a few in SS.
PM me, and I will send it N/C.
3/4" -- oval -- slotted -- SS -- new.
Best,
Fred
(http://i748.photobucket.com/albums/xx130/foakes1/2A11E480-6B3E-4BEE-9069-33989F5D79B9_zpsfynhv20p.jpg) (http://s748.photobucket.com/user/foakes1/media/2A11E480-6B3E-4BEE-9069-33989F5D79B9_zpsfynhv20p.jpg.html)
The screw you're displaying is a 6-40, filster head, for the bridge plate.
Sorry about that --
Post a pic of what you need by showing a good screw.
Have quite a few others.
Best,
Fred
Fred, This is the one I'm looking for. Thanks for your help.(http://i2.photobucket.com/albums/y28/THEBIGGUY/002.jpg)
Sorry, John --
Not opening for me.
Maybe use free photo bucket?
All the Best,
Fred
(http://i748.photobucket.com/albums/xx130/foakes1/2BECD26D-5FA9-40E2-9CEC-32FF805C9F36_zpsb2fn19zr.jpg) (http://s748.photobucket.com/user/foakes1/media/2BECD26D-5FA9-40E2-9CEC-32FF805C9F36_zpsb2fn19zr.jpg.html)
John:
Sent you a pm. I've got the screws.
Mike
Fred- I don't know what happened there but the image WAS there when it was first put up. Anyhow, looks like Mike has me covered. Thank you.
Mike- Pm's replied to. Thank you very much!
Thanks, John --
And thank you, Mike --
Lots of good help on this board!
Best,
Fred