Print Page - Penn formula 10Kg gear sleeve dimansions?

Title: Penn formula 10Kg gear sleeve dimansions?
Post by: trond_solem on December 07, 2014, 03:05:52 PM

I need to make a crank arm for the Penn Formula 10 kg reel. To do this I need to know the dimensions of the gear sleeve where the crank sits. Marsuring the hole in the crank arm may or may not be accurate enough. I prefer the measurements from the gear sleeve end
Someone who can help me with this?

Title: Re: Penn formula 10Kg gear sleeve dimansions?
Post by: alantani on December 07, 2014, 09:24:15 PM

crud. i had a 15 kg that i could have measured out for you, but i just shipped it out. :-\

Title: Re: Penn formula 10Kg gear sleeve dimansions?
Post by: David Hall on December 07, 2014, 11:15:27 PM

Got one I can measure but first I have to go back to the tutorial and see how to get the handle off!

Title: Re: Penn formula 10Kg gear sleeve dimansions?
Post by: David Hall on December 08, 2014, 12:48:36 AM

Got it.
9.6mm flat side to flat side
10.28 mm overall around.

From the crank

9.68 s-s
10.3 overall

Title: Re: Penn formula 10Kg gear sleeve dimansions?
Post by: David Hall on December 08, 2014, 12:51:22 AM

This is from my 10KG

Title: Re: Penn formula 10Kg gear sleeve dimansions?
Post by: trond_solem on December 08, 2014, 01:07:15 AM

Quote from: David Hall on December 08, 2014, 12:48:36 AM
Got it.
9.6mm flat side to flat side
10.28 mm overall around.

From the crank

9.68 s-s
10.3 overall

Great!
Thanks.

Reel Repair by Alan Tani

Conventional and Bait Casting Reel Rebuild Tutorials and Questions => Penn International Tutorials and Questions => Topic started by: trond_solem on December 07, 2014, 03:05:52 PM