Hi Dawn Can you tell me what washer # the Daiwa X40sha uses? The reason I ask is I only need 2 and not the 6 in the kit. Thanks Doug
If this is the right kit I get 8.6mm ID x 35mm OD x .65mm thick.
I am not sure what I need is a replacement for the Teflon washers for 2 430ss reels and I think these are really close Doug
I think I have that reel laying around. I'll check and see.
The Daiwa drag washer is too large on the OD. Scott's Bait and Tackle should have them. Part 56-440. If they are out I have 2 of them.
If you wanted to make your own they are 9mm x 31mm x 1mm thick. The stock HT-100 has ears.
The X40SHA and Saltist are not the same.
X40SHA is #54. 33.8mm x 9.5. It's 1mm thick.
The X20SHA is #48. 31 x 8.9 x 1. Maybe that would work.
Dawn
Sometime ago I replaced the washers on a x40sha with a kit from Dawn and saved the old felt ones They are almost a perfect fit in the 430ss and 714z I just didn't need 6 if I got another kit Doug
Handi2 Thanks for looking and your offer the 56-440 might work I tried a few but they are little small maybe the 4300ss is not the same as the older 430ss but I am sure the x40sha is a better fit Doug
Hi
I just went and looked at the washers. The X40SHA is exactly the same as the Penn SS430, just thicker.
Handi2 I think you might be looking at the SS440.
Dawn
Quote from: Doug on October 14, 2014, 12:08:57 AM
Handi2 Thanks for looking and your offer the 56-440 might work I tried a few but they are little small maybe the 4300ss is not the same as the older 430ss but I am sure the x40sha is a better fit Doug
Yes I found out that the 4300SS and 430SS are different.
Thanks
Thank you Dawn for looking I'll send in an order soon Doug