Quote from: Swami805 on May 10, 2024, 04:45:13 PMThat doesn't seem right, if it moves something is going to wear outYeah it's too big of a hole. Seller said so. It feels improper to screen shot a conversation or I'd show you. I took these pics to process the refund. Measured a stock 98-60 lest someone (unfamiliar with them) say maybe the issue was the aftermarket sleeve.
Quote from: JasonGotaProblem on May 10, 2024, 03:51:10 PMI ordered one of these online because options seem to be limited for jigmaster handle blades that aren't offset. (Am I the only person with big fingers here? How does nobody else have this problem? with an offset handle my fingers struggle to fit between the offset handle on a narrow reel and a non-skinny rod?)
Quote from: boon on May 10, 2024, 01:05:22 AMI'm a bit torn. I have a little Honda stationary engine (GX270) and I have spent far more on genuine Honda parts to recondition the carb than a complete chinese clone carb would have cost me.
But then I would be supporting a business that does nil product development, and has just copied the Honda item, to unknown tolerance, specification, metallurgy etc. Would the chinese clone product probably do the job perfectly well? I would say there's a very, very good chance it would. But until the price difference becomes eye-watering, I will endeavour to use genuine parts.
EDIT: This does not apply when one can find out the originator of the genuine part, and buy it direct at a major discount with different branding. That's just being smart.
Page created in 0.023 seconds with 10 queries.