I have purchased screws, dog springs and other items from this ebayer and I have to tell you it's been a total pleasure. Glad to see they are keeping the Newell faith alive!
I have been dealing with him about a year. Always good
Mike
Hey Mikey, you're back! Good. we need some more Nor'easter's to represent.
I'm here every day. I check 2-3 times a day. There are enough Newell guys here so I'm quite. If I have to I jump in.
Mike
Whittierte has filled a much needed void in my Newell inventory. Good to see more producers for parts that very hard to acquire.
I've bought a fair amount of parts too to keep on hand all the things I was hoarding as unobtainium or you can find but only in large quantities. Be nice to find shift levers in stainless that didn't cost a fortune. One of the beauties of Newell s is the parts interchangeability between models
Thanks for making this stuff available
A lot of whittierte's items are made by Tom Hryniuk/Cortez Conversions. Can't get any better then that! I would like to see stainless snap in bearing buttons for the S Series right bearing cover. Newell made these for awhile to replace the plastic one. Plastic one shown below:
thanks for posting that Frank, I had wondered about that - I've got one with the stainless cap. didn't know the plastic button was removeable. and yes, great these parts are being made available, hopefully more to come...
Glad it was helpful! Yes, you can pop them out using a punch from the inside. Just a light tap.
this one
If you look at a schematic that comes in each box the instructions tell you to push the cap out with a screwdriver inserted through the bearing. Then push against the bearing from the outside to get the bearing out. I have been successful using a puller and not risking breaking the plastic piece.
Dwight
Where can I get that stainless cap. I don't like the plastic there. I could use a stainless bearing cap for clicker side too.
whittierte has the clicker side, don't know about the other side, I could use a few if they turn up.
Post a link.
WHY hasn't anyone made YOKES for Newell Reels? I've heard promises but only heard Crickets. I have sat at a table with 4 people & 1 person said he had them cut & waiting for the press to bend them. That was over a year ago.
Mike
Anyone know if they have the e-clip for the handle?
Quote from: Caseymcv on September 19, 2019, 01:42:01 PM
Anyone know if they have the e-clip for the handle?
PM sent
Quote from: bluefish69 on September 02, 2019, 04:48:18 PM
WHY hasn't anyone made YOKES for Newell Reels? I've heard promises but only heard Crickets. I have sat at a table with 4 people & 1 person said he had them cut & waiting for the press to bend them. That was over a year ago.
Mike
I'm still waiting for a press mold to bend the tabs. I'd better as Tom...I'm sure it's on his list but don't know were it is on his list.