What's the difference between the MAK and the MAK SEA?
The Sea have open bearings lubed with TSI 301 and the handle from the next larger reel. The 20/30/50 have a lower low gear ratio.
From the Okuma site:
Features
Open spool bearings with TSI-301 oil. Increases freespool 2-1/2 times.
MK80WIISEa and MK-130IISEa feature grease-packed spool bearings.
All non-spool bearings feature full grease pack for maximum longevity.
Features Special Edition Gun Smoke and Black anodizing.
SE reels feature a yellowfin tuna etched into the sideplate.
Frames have been machined out for increased clearance between spool and cross bars.
MK-8/10/15 feature MK-20 size handle knobs.
MK-20/30 feature the MK-50 handle arm and knobs.
Lower speed 1.3:1 gear ratio featured in 20/30 sizes.
Lower speed 1.0:1 gear ratio featured in 50 size.
Type-II gunmetal anodized frame, side plates, spool, drag lever and handle.
Quote from: MarkT on May 08, 2017, 03:22:10 AM
The Sea have open bearings lubed with TSI 301 and the handle from the next larger reel. The 20/30/50 have a lower low gear ratio.
Thanks Mark. So the only difference is the bearings and the larger handles?
the sea also has a lower gear ration on the low end, plus a heavier spool shaft. all around a beefier reel.
Quote from: alantani on May 08, 2017, 03:52:14 AM
the sea also has a lower gear ration on the low end, plus a heavier spool shaft. all around a beefier reel.
Thanks Alan. I'm convinced I'll be getting a 20 II.
I have the 16 and 20 SEa's in silver.
Quote from: MarkT on May 08, 2017, 04:00:28 AM
I have the 16 and 20 SEa's in silver.
How much line were you able to put in the 20?