Any tips on getting this back together? Both pieces are under load to install, but behind the head plate.
it's upside down...... :-\
Hmm. Processing... The plastic part is as it came apart. It has a small lock nut on the screw. Will not come apart. So I left it where it was.
oops, yeah, i see that now. remove this click switch cam (key #2721) from the side plate and seat it back into the one piece frame (key #2916). you will have to alight the click switch cam with the click link (key #2907) and then set the click switch spring (key #2723) into the tiny hole of the one piece frame. when the reel is ready to go back together, install the right side plate (key #2881), then the click switch (key #2683), and then the screw for the click switch (key #2228).
https://www.mikesreelrepair.com/content/schematics/Shimano_CTE70028ARB29.pdf
Thank you! The shaft running through is threaded at both ends. Just needed a little pressure and holding the other end to get the screw from the outside to release. Thanks again!
Andy