Print Page - S/S GEAR SLEAVES

Title: S/S GEAR SLEAVES
Post by: capnpiney on May 25, 2009, 07:29:38 PM

Hi Alan

Are there ss gear sleeves available for the 3 and 4-0 senators...put some on my squidders and liked the fir ive a few 3-0 that are "loose " and would like to tighten them up
Thanks Nick

Title: Re: S/S GEAR SLEAVES
Post by: alantani on May 25, 2009, 10:45:15 PM

hi, nick! the 98-60 and 98-505 gear sleeves work on the 500 series reels and all of the senators from the 111 to 113. note that the 113h uses a 98-349h gear sleeve and there is no stainless steel upgrade for this reel. at least, not yet.........

Title: Re: S/S GEAR SLEAVES
Post by: capnpiney on May 27, 2009, 12:51:12 AM

Hello Back Alan

On the 113 h on line schematic I see a gear sleeve listed as a 98-320 /star 10-349 ??? miss print at scotts ,this # is only for the half frame model correct?Whats your intake on the fine versus coarse sleeve/star combo ,pro's /cons ...Id like to get 3 ss sleeves ,if you need the star numbers i'll have to wait until after this w/e to get that info to you(rods on boat),or if id get any performance advantage with a fine thread ,hope im making scence here .

Thanks again

Title: Re: S/S GEAR SLEAVES
Post by: alantani on May 30, 2009, 02:50:58 AM

oops! you're right, nick. the gear sleeve is a 98-320. i've got my machinist looking at a stainless steel gear sleeve upgrade. we will probably need a stainless steel star as well. these are all for the "red side plate" reels.

there is a "black side plate" 113 that takes a jigmaster 98-60 gear sleeve. different reel. alan

Reel Repair by Alan Tani

Conventional and Bait Casting Reel Rebuild Tutorials and Questions => Penn Senator Tutorials and Questions => Topic started by: capnpiney on May 25, 2009, 07:29:38 PM