Text only | Text with Images

Reel Repair by Alan Tani

Conventional and Bait Casting Reel Rebuild Tutorials and Questions => Penn International Tutorials and Questions => Topic started by: Andiesean on December 13, 2010, 05:28:29 PM

Title: Penn Int 130
Post by: Andiesean on December 13, 2010, 05:28:29 PM
Any tutorials on Penn Int 130's? I have 2 130S's and 4 130ST's I want to tear down and clean up. Thanks for any help!!

Title: Re: Penn Int 130
Post by: kamuwela on December 13, 2010, 07:54:42 PM
the st is real easy if you follow any of the early penn tutoriols you will get it done ive done a few in the penn section of this site, look at the 50t its almost identical except yours is 2 speed and dual drag. look through it and youll find it aint so hard good luck.                                           aloha
                                                                    kamu
Title: Re: Penn Int 130
Post by: Andiesean on December 13, 2010, 08:41:50 PM
Thanks I will take a look at what you mentioned!!

Title: Re: Penn Int 130
Post by: kamuwela on December 14, 2010, 03:41:41 PM
pm me if you need help
Title: Re: Penn Int 130
Post by: Andiesean on February 25, 2011, 11:16:20 AM
I just wanted to say thanks Kamu!! I tore down all six 130's, very easy, only found one issue, easy fix.

Thanks again!!

Title: Re: Penn Int 130
Post by: kamuwela on February 25, 2011, 04:22:09 PM
anytime glad you got it done
                    aloha
                     kamu
Title: Re: Penn Int 130
Post by: 458steve on October 03, 2017, 11:44:05 PM
Question - I have an old Int. 130H and I am getting a lot of gear noise and I can only find a high speed pinion shaft for the 130H.  I can get a set of main gear and pinion for a 130 original low speed. Can I just replace the 130H pinion to clear this up or should I replace them as a set in original 130 gearing. Thanks
Title: Re: Penn Int 130
Post by: Tightlines667 on October 03, 2017, 11:56:01 PM
Quote from: 458steve on October 03, 2017, 11:44:05 PM
Question - I have an old Int. 130H and I am getting a lot of gear noise and I can only find a high speed pinion shaft for the 130H.  I can get a set of main gear and pinion for a 130 original low speed. Can I just replace the 130H pinion to clear this up or should I replace them as a set in original 130 gearing. Thanks

See my reply to your duplicate post.
Text only | Text with Images