Reel Repair by Alan Tani

Conventional and Bait Casting Reel Rebuild Tutorials and Questions => Penn Senator Tutorials and Questions => Topic started by: vinestbrew on July 21, 2009, 09:53:19 PM

Title: New here!! Question about senator drag?
Post by: vinestbrew on July 21, 2009, 09:53:19 PM
Hi Alan I have seen many posts of yours on various other boards and have found them extremely helpful. Thanks!! I have a penn 114hlw and was having problems with the drag slipping so I tore it down and replaced it. However now when I crank the drag down the star drag tightens all the way down to the side plate. It's almost as if the spacing sleeve is to short. Anything I should look for?
Title: Re: New here!! Question about senator drag?
Post by: vinestbrew on July 21, 2009, 11:39:06 PM
Another thing to add when the spring disk is installed the drag slips, with it removed the drag doesn't slip?
Title: Re: New here!! Question about senator drag?
Post by: alantani on July 22, 2009, 05:02:55 PM
i don't have a full rebuild post on the 114h, so check the schematics https://www.mysticparts.com/Assets/images/pennparts/schematics/114h_post.pdf (https://www.mysticparts.com/Assets/images/pennparts/schematics/114h_post.pdf) and make sure you have all the washers in proper order.  it actually sounds like the carbon/metal washer stack is not tall enough.  that might account for the fact that the star is bottoming out.  there are two thick wave washers.  perhaps try putting the thin one underneath the spacing tube.  you will know that there is NOT enough room if the handle binds up when the drag is backed off.  alan


"Edited as per Moderators to correct Scott's Bait & Tackle over to their new store name Mystic Reel Parts / www.mysticparts.com"
Title: Re: New here!! Question about senator drag?
Post by: vinestbrew on July 29, 2009, 03:50:47 AM
Alan, I added an few extra drag washers and it's seems to have solved the problem. I'm assuming  this will increase my Drag settings and if so what are the chances of damaging the gears.
Title: Re: New here!! Question about senator drag?
Post by: alantani on August 05, 2009, 12:26:36 AM
you should be good for 80# mono and 24#'s of drag without any problems.