Print Page - Shimano Tekota 600LC - Clutch Pawl Spring ?

Title: Shimano Tekota 600LC - Clutch Pawl Spring ?
Post by: Drisse on July 03, 2015, 03:15:52 PM

Hi !
I bought a new Clutch Pawl spring for a Shimano Tekota 600LC. Partnumber: TGT0635. Bought it on EBay and the little plastic zip-bag was only marked TGT0635 with a pen. I wonder If I got the right spring ? I think it looks to small for this reel. Does anyone have a Shimano Tekota 600LC and are able to take a look at the spring ? In one of the pictures I measured the circle diameter on the spring.

Title: Re: Shimano Tekota 600LC - Clutch Pawl Spring ?
Post by: Lunker Larry on July 06, 2015, 08:06:31 PM

I've done a lot of these reels. Don't have one to compare but that spring looks correct.

Title: Re: Shimano Tekota 600LC - Clutch Pawl Spring ?
Post by: Drisse on July 07, 2015, 12:06:23 AM

Hi, thanks Lunker Larry !

It looks correct, but I think it should be one or two sizes bigger. Its so tiny it easily fall of.

Title: Re: Shimano Tekota 600LC - Clutch Pawl Spring ?
Post by: Lunker Larry on July 07, 2015, 01:41:29 AM

Yes. It can be a bit of a pain at times as it is not a tight fit until everything is put together.
good luck

Title: Re: Shimano Tekota 600LC - Clutch Pawl Spring ?
Post by: alantani on July 09, 2015, 08:14:30 AM

i believe you have the correct spring. if it does not work properly, try reversing it. it does work better, one way versus the other. i just cannot remember which way is proper.

Title: Re: Shimano Tekota 600LC - Clutch Pawl Spring ?
Post by: Drisse on July 09, 2015, 08:33:04 PM

Thanks Alan. Then I guess its the right one. Will give it a try.

Reel Repair by Alan Tani

Conventional and Bait Casting Reel Rebuild Tutorials and Questions => Shimano Tutorials and Questions => Topic started by: Drisse on July 03, 2015, 03:15:52 PM