I have an old Mitchell 308s reel that was made in France. The anti reverse does not work. To get at the anti reverse dog and spring I need to remove the pinion gear from the housing. I've looked over the housing and cannot find either a set screw or pin holding the pinion assembly in place. Does anyone know how to remove the pinion so I can fix this reel.
Welcome aboard, Mike --
There is a tiny black keeper set screw on the handle side -- right at the neck.
Accessible easily with a micro screwdriver --
Usually hard to see until you know where it is.
If you need a schematic -- just let me know, and I will post one.
Show us the reel when you are done!
Really excellent and tough little reels.
Best Regards,
Fred
Here you go, Mike --
Lots of times either those are covered with grease and grime -- or my work glasses are!
Best,
Fred
Here is the one you need for the 308S, Mike --
There is no screw -- instead there is a key at the bottom of the body housing neck.
Best,
Fred