Have a 112 on the work bench and it needs a clicker. Being in the middle of Canada I have no idea where to get the part and also cannot find a schematic. Clicker must have been used over the years to slow the line being let out.
Also, how does it come apart?
Appreciate your time and help.
Larry L
Good question. been in a few OC's over the years, but can't remember. Older Penn's godda be ground-off and and a new one either peened-on or installed with a circlip. Can check a little 979 that I have, guessing it's too small, though.
They are peen on . It may be easier to get a tail plate replacement ..
I think Dominic may have some spare parts ...
You can't get there from here. New old stock is probably nonexistant. Old ones can't be reused without a spot of weld to build up and then grind down the pawl and post before reinstalling.
Thanks all. Too bad. Pretty much new condition.
It's a reel his dad had and he just wanted to get it cleaned up. Don't think he had intentions of using it. Just a Good keepsake now.
Hi Mr Lunker, the is a product made in the USA, Rapid Fix, dual adhesivo system, it actually weds the two parts together, just place a little powder were required, then add the liquid, & it instantle welds the two parts with very little heat, so as long as you have the shaft, make u tongue, & presto, good luck, cheers Don.
Quote from: Donnyboat on June 07, 2022, 03:04:32 AMHi Mr Lunker, the is a product made in the USA, Rapid Fix, dual adhesivo system, it actually weds the two parts together, just place a little powder were required, then add the liquid, & it instantle welds the two parts with very little heat, so as long as you have the shaft, make u tongue, & presto, good luck, cheers Don.
I'll look that up and thanks.
The reel has Made in Phila USA on the plate and a "B" on the bottom of the foot. Out of curiosity, what year would this reel be around.
Ocean City 112 side.jpgOcean City 112.jpg
Got a lot of New Old Stock Ocean City parts, Larry —-
Mostly internals.
But as stated previously, the clicker is riveted in place on the tail plate.
Here is a OC 112 that I could either send you the tail plate off of —- or the entire reel, your choice.
No Charge.
The reel operates perfectly and smoothly —- missing a crank.
Clicker is good and strong.
Will be heading down to Fresno today —- so if you let me know fairly soon —- it will ship today.
Best, Fred
Hope I caught you in time. Just the side plate would be great and very much appreciated.
Your assistance and generosity is very much appreciated.
I'll PM my address as soon as I figure out how.
Regards,
Larry L
Quote from: Lunker Larry on June 07, 2022, 07:10:51 PMHope I caught you in time. Just the side plate would be great and very much appreciated.
Your assistance and generosity is very much appreciated.
I'll PM my address as soon as I figure out how.
Regards,
Larry L
Thanks, Larry —-
Got your address —-
Will mail today.
Best, Fred
I am sorry Fred but I have been delinquent in expressing my thanks for sending me the side plate. It seemed like every time I was away from my computer I would remember and then forget when I got home. A poor excuse but it's been a busy summer so far.
I am just one of the legion of people on this site that you have assisted through your kindness, generosity and knowledge. I am grateful and hope to someday have the opportunity to repay in kind.
Larry L
Great, Larry —-
Hope it fit OK and you are happy with it.
Best, Fred
Just reading this thread today. I have some spare parts for OCs. PM me if anyone needs a part. Dominick