I am looking for an extended handle for a 12/0, (5 or 6 inches) or can someone open up a 6/0 9/0 handle hole to accommodate a 10/0 12/0? Also I'm guessing if we do this a stainless sleeve may be necessary? Thanks.
Pro challenger on here makes an offset handle for 10/0 to 16/0, might be worth a look. 125 MM
I talked to Alan at Pro Challenger but that handle is only 1 1/4" longer.
I have an older, but clean 5.5" power handle from a 114H. It has 3 sizes of mounting holes and a 3.75" black plastic handle mounted at 90 degrees. I can't get the lock screw off my old 12/0, but I believe the nut is the same for the two models. Used, but not corroded and certainly not jazzy. No maker on it and the handle grasp has about 1/8" end play. The peening is tight so I believe that's how it's made so it will spin freely. Trade for a 80's era 114H handle in like condition?