Going to be replacing washers in an Okuma Epixor EB 50 spinning reel. Not a popular reel but I figure Dawn may have something that will work.
It's a 3 washer stack, I can measure OD and ID but when measuring thickness on old washers is it wise to add a bit to make up for wear?
Okuma spinners, like many others, are 1mm thickness. Daiwa are sometimes an exception using .5mm ;)
Good to know, thank you.
On these Okuma spinners, Rob —
There are a few ways to go on CF's —
— Smooth Drag will have something that will work
— Just get a small sheet of CF to cut your own (very simple)
— Or, just get (3) Penn 6-309's — they just drop in — that is what I generally do — quick and easy. The hole in the middle is slightly larger — but the OD is perfect, and the thickness is just right. I like the center hole slightly larger than the spool shaft or arbor — as long as the OD is perfect. Works good.
Here is a new spool like yours, as an example — just subbed the 309 HT-100's, greased them with Cal's — ready to roll.
The original factory drags are also decent — felt impregnated with oil. CF's or HT-100's are better for smoothness and longevity.
Best,
Fred