This stainless steel screw is available at my online store https://squareup.com/market/pro-challenger-llc (https://squareup.com/market/pro-challenger-llc)
This screw will fit the following reels
100M
109M
109M-LH
110
111
112
112H
112H2
113
113L2
113-LH
125
130 (Sailfisher)
140L
140L-LH
145
146L
149L
150
155L
155-LH
160L
165
180
185 Baymaster
185 Seaboy
190 (up to 1990)
190 Seaboy (1990+)
200M
209LC
209M
209M-LH
210M
25
250
259
26
267
268
27
285M
309M
309M
349
349H
349HC
350M
49L
49L-LH
500
500-LH
500S
501
505HS
506HS
60
60-LH
65
66
67
68
85
970
980
99
(http://alantani.com/gallery/26/771_08_12_18_8_19_23.jpeg)
(http://alantani.com/gallery/26/771_07_12_18_8_15_40.jpeg)
Nice! Do you have stainless bottom screws also for one stop shopping?
Quote from: Frank on December 08, 2018, 03:26:35 PM
Nice! Do you have stainless bottom screws also for one stop shopping?
No, not yet. I will later
Tagged for follow up.
-g
Just use 4 of his screws. No problem.
Are they $5.00 ea?
Joe
Quote from: handi2 on January 07, 2019, 12:30:00 AM
Just use 4 of his screws. No problem.
X2!
Takes the guess work out and could never get mixed up.
Sal
nice
Quote from: handi2 on January 07, 2019, 12:30:00 AM
Just use 4 of his screws. No problem.
So simple and it went right over my head.
The screws are beautifully machined, almost a piece of art.
What type of SS are they made of? Hardened? If yes before or after machining ?
Quote from: badfish71 on January 08, 2019, 04:07:33 PM
What type of SS are they made of? Hardened? If yes before or after machining ?
;D ;D ;D ???
Joe
Quote from: badfish71 on January 08, 2019, 04:07:33 PM
What type of SS are they made of? Hardened? If yes before or after machining ?
It is 304.
Keith and Sal brought up a good point... do we really need the bottom screws to be fully threaded for any particular reason? ...a little more grab?
Thanks
Dom
Quote from: broadway on January 08, 2019, 08:44:17 PM
Keith and Sal brought up a good point... do we really need the bottom screws to be fully threaded for any particular reason? ...a little more grab?
Thanks
Dom
Really no reason..
Quote from: broadway on January 08, 2019, 08:44:17 PM
Keith and Sal brought up a good point... do we really need the bottom screws to be fully threaded for any particular reason? ...a little more grab?
Thanks
Dom
Since this upper bridge screw will also work as the low bridge screw, there will have no reason to make the full threading low bridge screw.