What's the easiest way to remove the left bearing cap that is chipped that can't use wide blade screwdriver to remove without damaging the side plate? Heat or cold with easy out and drill? I bought this at swap meet and also has gear grinding noise when turn on its side. Could this also be bad bearings?
for the grinding noise, check the bearings for corrosion and check the gear teeth for the slightest amount of wear. know also that stainless steel newell gears are notoriously noisy, even when brand new. :-\
Sounds like you have a plastic bearing cap. Just remove the entire side plate [3 screws] & servive from the inside.
Quote from: alantani on May 10, 2012, 03:53:16 AM
for the grinding noise, check the bearings for corrosion and check the gear teeth for the slightest amount of wear. know also that stainless steel newell gears are notoriously noisy, even when brand new. :-\
I had the pleasure and honor to meet Carl once, some years back. Talking wahoo with Carl was awesome, no, it was better than that!
He believed the grinding of his straight cut gears actually acted as an attractant for wahoo. That was and still is, good enough for me.