Folks,
I'm not sure if this is the right spot, but I'm desperately seeking a stainless steel left hand Squidder gear sleeve. Does anyone have one that is available for sale?
MQ1
I may already be three sheets in to the wind on my birthday, but I think you can modify any righty sleeve to work just by filing down the ramps. The star has the same thread I think-?
I have a few of these in use that if I recall correctly were a saved large batch that were cut as lefties instead of righties. No ramps, they act the same either way.
This pic is of a larger ambidextrous sleeve and a ready to go righty Squidder sleeve. I might be just hammered though.
Use a stainless dog too-
I think lefties have a reverse thread for the drag star. I can check some JigMasters and 4/0s tomorrow.
You are right, I was hammered. They do take a LH star.
::)
Thanks for the thoughts, Jose...you got me thinking!
MQ1
I got one from Alan years ago. Not sure if he still has any or not.
Quote from: kmstorm64 on June 24, 2021, 03:22:09 PM
I got one from Alan years ago. Not sure if he still has any or not.
boy, you've got a good memory! yeah, that was a one-off mistake by the machine shop that i was using at the time. it's all doable, but just not at a reasonable cost.
Very Nice Trick on the filing Jose ,gotta member that one.
NOT SURE BUT ?
Would the plain old 113 not H but the old smaller sleeve be the same IF so Mo (Mystic Parts) has them and the Star . I am building one now for the Heck of it