That looks great to me Bryan.
I have made many repairs like yours and you have to do what you have available.
Kudos to you sir. ;)
I think you did really good, it should actually be better. I'm not sure why Penn never used a metal pin there, I had to do the same on a couple of large Senators in the past.
Shouldn't be telling the master this, but you should make the tip on that spring flush with the eccentric ;D
It is always a good idea, since it rides against the Jack, but not necessary on larger reels, as the 4/0 and up.
Very good Bri-Bri!
Sal
Looks like a good fix to me as well Bryan - thanks for sharing, it gives us another trick up our sleeve.
Mike
Just noticed the eccentric says 114...scratch my comment above, I thought I would finally be one up on you ;D.
Sal
How is it that these things break, anyway? I've seen a few now.... Does the mechanism somehow jam and then the operator forces the shift lever? I've seen the eccentric jack move a little sideways at times, especially when that little tab from the spring that Sal pointed out contacts the jack, but I don't remember that happening in the 114/h, which I think is what Sal was alluding to in his second post immediately above..... part of this story has not yet been revealed.....
Sounds probable Sid, or maybe suddenly pushin it into gear with the spool a spinnin. Looks better than ever Brian. Why replace a head-plate for somethin like that?
Great fix, Bryan!
Thanks,
Fred
Fred, any insight on how these things break?
Your lucky the stand was still there. I recently work on a 112 that was sheered flush with the inside of the plate.
Joe
Nice job Bryan. I would have built up the plate with JB Epoxy before drilling and tapping. Let's hope it holds up. Dominick
Great job, Bryan, I'm sure this will help many others in the future, thanks!
Nice work, Bryan!
Quote from: Dominick on January 28, 2019, 09:08:25 PM
Nice job Bryan. I would have built up the plate with JB Epoxy before drilling and tapping. Let's hope it holds up. Dominick
auto body ,,,, :) you run into this problem,,,, ??? 3m panel bond it's 10 times stronger than jb,,,,but it takes 3hr to set up and then you can sand it to any shape,,,down side is it $38 for 6.75oz,,,, ;) but I think you did a fantastic job with out it,,,, ;D
Quote from: Dominick on January 28, 2019, 09:08:25 PM
Nice job Bryan. I would have built up the plate with JB Epoxy before drilling and tapping. Let's hope it holds up. Dominick
I think it'll hold. The screw is 3/8" long. My greatest fear was actually drilling through the sideplate. Luckily, that didn't happen. The head was also ground down smooth to ensure that there would not be any binding. If they break the post including the screw, something else would majorly go wrong.
Thank you for sharing your solution Daron. I see how that works well.
And thank you everyone for your encouragement. Now my brain can rest considering.
Mahalo,
Bryan