Quote from: Jmagri on Today at 08:36:10 AMDo you know of that drag insert for the main gear are still available anywhereI think I have some but I'm out of town til Tuesday. I'll check when I get back if I remember.
Quote from: Dunky on Today at 10:42:54 AMSounds like you'll fit in just fine around here.Quote from: JasonGotaProblem on May 25, 2024, 02:31:13 AMSo what do you fish with? Welcome.I have Penn both spinning and conventional Shimano both as well. Couple of Accurate and a few quantum Cabo I vanstaal 275VM that is unused. I mostly fish for stripers blues and I hoping to catch blue fin tuna. I also fly fish
Chris
Quote from: JasonGotaProblem on May 25, 2024, 02:31:13 AMSo what do you fish with? Welcome.I have Penn both spinning and conventional Shimano both as well. Couple of Accurate and a few quantum Cabo I vanstaal 275VM that is unused. I mostly fish for stripers blues and I hoping to catch blue fin tuna. I also fly fish
Quote from: Shark Hunter on September 27, 2015, 07:20:33 AM16/0 and 14/0 plate ready to be cut for double dogs.
I had an unexpected surprise when putting the finishing touches on the 16/0 plate. My Dremel let out a few sparks and made a funny noise. I let it cool off. I went to start it again and it started smoking immediately and burst into flames. I unplugged it and threw it into the driveway.
That thing only lasted 10 years. Had to run down to Wally World and pick up another.
Plates all done.
Out with the old, In with the new. Everything polished and cleaned. Its late. I'll finish her up tomorrow.
Quote from: Shark Hunter on September 27, 2015, 07:20:33 AM16/0 and 14/0 plate ready to be cut for double dogs.Do you know of that drag insert for the main gear are still available anywhere
I had an unexpected surprise when putting the finishing touches on the 16/0 plate. My Dremel let out a few sparks and made a funny noise. I let it cool off. I went to start it again and it started smoking immediately and burst into flames. I unplugged it and threw it into the driveway.
That thing only lasted 10 years. Had to run down to Wally World and pick up another.
Plates all done.
Out with the old, In with the new. Everything polished and cleaned. Its late. I'll finish her up tomorrow.
Quote from: Swami805 on May 17, 2024, 01:52:49 AMSeems to me it would matter in that location, I think I would want the right thickness there
Page created in 0.016 seconds with 11 queries.