g220-f cross bars appear to be wider(between the screw holes)than the p220-f.
Is this correct?Length seems to be the same.
Any g220-f cross bars available?
I think I've got G220 posts so I can compare to the P220. The widths of the holes between a P and G should be the same. Perhaps the G posts are a bit wider but the ring holes would still line up if you put on a P post. Yes,the lengths will be the same.
I'll look for the posts and get back to you.
circuits00:
Ok, I've compared the P and G posts for a 220/322. The holes line up just fine. Yes, the width of the G posts are a bit wider but that's just the way it was designed.
i have some beat up cross bars. if you could get some calipers and give me an exact lenght, i will see if anything matches.