Print Page - Penn 113H2

Title: Penn 113H2
Post by: Boatzilla on January 02, 2015, 07:26:20 PM

Hello Alan,
I am trying to solve a problem I am having with the Penn 113H2 reel.
I manufacture, repair and sell the Precision Auto Reel drive system and the Penn 113H US version was very popular.
When Penn changed to a male thread on the bridge sleeve, I immediately started having issues with my drive system shearing off this male thread.
Failure rate was approximately 60-70%.
I stopped offering the 113H2 reel due to this issue.
Do you know of anyone offering a replacement sleeve in stainless steel that would fit this application?

Any help would be greatly appreciated.

Thank you

Dave

Title: Re: Penn 113H2
Post by: alantani on January 02, 2015, 07:37:33 PM

we could make one, not sure it would be cost effective!

Title: Re: Penn 113H2
Post by: RowdyW on January 03, 2015, 12:08:54 AM

The 113h &hl gear sleeve will fit in place of the h2 sleeve. Then you can use h & hl parts on the outside of the reel. RUDY

Title: Re: Penn 113H2
Post by: Boatzilla on January 03, 2015, 04:19:36 AM

Thank you for the sleeve changeout idea. I tried changing the entire bridge assembly without success.

I will try changing out just the sleeve.

Thank you

Dave

Title: Re: Penn 113H2
Post by: alantani on January 03, 2015, 04:39:11 AM

if you decide you want to try a stainless steel sleeve, i can supply those.

Title: Re: Penn 113H2
Post by: Boatzilla on January 07, 2015, 07:49:34 AM

Thank you very much for the SS sleeve offer, I will be trying again soon.

Dave

Reel Repair by Alan Tani

Conventional and Bait Casting Reel Rebuild Tutorials and Questions => Penn Tutorials and Questions => Topic started by: Boatzilla on January 02, 2015, 07:26:20 PM