I have two Penn Senator 9/0's (one and a half, really) Both are in pieces.
All side plates utilize the NEW bearing.
There are two different spools.
Spool A: (Assuming the older spool)
Handle side shaft length: 1.070" (tip to spool) - the older bearing extended further into the reel
Inside diameter (where line spools) .700"
Left side (clicker/non-handle) shaft diameter: .155" (+.005" maybe)
THIS SPOOL FITS INTO THE LEFT SIDE (NON-HANDLE SIDE) BEARING (shaft fits into bearing opening)
Spool B: (assuming the newer spool style:)
Handle side shaft length: 1.390 (makes sense, as the new bearing doesn't extend into the reel)
Inside diameter (where line spools) .830"
Left side (clicker/non-handle) shaft diameter: .190" Does NOT fit into the bearing.
THIS SPOOL DOES NOT FIT INTO THE LEFT SIDE (NON-HANDLE SIDE) BEARING (shaft fits into bearing opening)
All the schematics I've viewed show only one left side bearing for all models.
Note: Both reels are the same width, and the "Bell" or side of the spool are both 3.75" on each spool
Is there a different left/non-handle side bearing??? All other information I can find addresses the change in the spool, the right side bearing, and the spool. I have not found any information on the left side bearing.
this is all i've seen. https://www.mysticparts.com/PennParts/Technical/115LDesignChangeRight.aspx (https://www.mysticparts.com/PennParts/Technical/115LDesignChangeRight.aspx)
i send a pm to ryan at mysticparts.com
Hello Rogve,
Your best bet is to look at the following two pages on our site regarding the design changes for the 115L.
Right Side Bearing: https://www.mysticparts.com/PennParts/Technical/115LDesignChangeRight.aspx (https://www.mysticparts.com/PennParts/Technical/115LDesignChangeRight.aspx)
Left Side Bearing: https://www.mysticparts.com/PennParts/Technical/115LDesignChangeLeft.aspx (https://www.mysticparts.com/PennParts/Technical/115LDesignChangeLeft.aspx)
"Edited as per Moderators to correct Scott's Bait & Tackle over to their new store name Mystic Reel Parts / www.mysticparts.com"
MOST EXCELLENT!!!!
Thanks much. I don't know how I could have missed this before....
you and i both missed it. ryan said it was at the bottom of the page and he moved it to the top!