Almost finish a rebuilt of a 750ss and notices after upgrading the drags with Bryan's kit that the drag tightens itself when testing the drag
Using the stock drag knob if it makes a difference
What would cause that?
Marc..
Bad orientation of the washers.
Man!! I can't even read a plan right, my situation is getting worst and worst ::)
Thanks Sal!
Marc..
If washer order looks good, you might try measuring the height of the new stack and checking it against the old.
A stack that sits too low can allow the drag knob to touch the spool, leading to both of them turning together as a unit.
Chad
Quote from: cbar45 on March 13, 2016, 09:40:24 PM
If washer order looks good, you might try measuring the height of the new stack and checking it against the old.
A stack that sits too low can allow the drag knob to touch the spool, leading to both of them turning together as a unit.
Chad
Order was right but the orientation was not
Marc..
Good to know, I was wrong on the height of the new stack being a possible factor.
Chad