Print Page - 114H narrow

Title: 114H narrow
Post by: AlasKen on May 27, 2016, 05:29:42 PM

I finally had some time to work on some Tiburon frames I got from Randy. Started with a 114H using Alan's 5/0 handle and Gen II kit, Three Se7ens drag kit and misc other stuff I don't remember right now. Wouldn't you know it the darn dog spring up and disappeared on me. I put it together without the spring in order to make sure everything went together as it had been a while since I tore it up. When I get this one I have another Penn half frame and spool to do my other 114H with and then on to a 113H. I need to just order me a half a dozen dog springs for 112H, 113H, and 114H. :)

Title: Re: 114H narrow
Post by: RowdyW on May 27, 2016, 07:59:08 PM

Ken, the 112H & 113H use the same coil spring. The 114H uses a flat brass spring that you can cut out of a piece of sheet brass. Rudy

Title: Re: 114H narrow
Post by: AlasKen on May 27, 2016, 08:54:35 PM

Thanks Rudy. Perhaps I can find some brass locally.

Title: Re: 114H narrow
Post by: RowdyW on May 27, 2016, 10:19:34 PM

If you have a local hardware store look for a piece of shim stock about .010" thick.

Title: Re: 114H narrow
Post by: AlasKen on May 27, 2016, 10:44:22 PM

Thanks. That helps. KCD

Title: Re: 114H narrow
Post by: David Hall on May 28, 2016, 01:59:47 AM

I made some out of the spring from a bic lighter, just pry it off the top, grind the ears off and good to go.

Reel Repair by Alan Tani

Conventional and Bait Casting Reel Rebuild Tutorials and Questions => Penn Senator Tutorials and Questions => Topic started by: AlasKen on May 27, 2016, 05:29:42 PM