Here are the dimensions updated for the DIY
The TLD 30II sleeve allows belleville stack changes with no shimming required.
All lengths are the recommended staring length (.003" over).
Accurate Sleeve length OD Wall
Platinum TD 50W 2.397 10mm .45mm
Platinum TD 50 1.701 10mm .45mm
Platinum TD 30 1.607 11/32" .014"
Platinum TD 12 1.469 11/32" .014"
Platinum TD 6 0.88 11/32" .014"
Boss 870 1.15 7/32" .014"
Boss 665 HW 1.672 7/32" .014"
Boss 665 H 1.245 7/32" .014"
Boss 270 0.957 7/32" .014"
Boss 197 0.441 7/32" .014"
Boss Ex 500 1.143 7/32" 0.014"
Boss Ex 600W 1.664 7/32" 0.014"
Cavalla 15II 1.496 0.014"
TLD 30 II 1.792 5/16" 0.014" Remove two inside C clips
TLD 15 1.419 9/32" 0.014" Remove inside C clip
TG 15 1.428 9/32" 0.014"
Jim N.
By they way, these sleeves are also available by contacting Jim via a PM. I believe they are $10 each plus shipping.
Thanks for the info. Jim!!!
Again, thanks for all your help on the Accusleeves I ordered. All my Accurates are now sleeved and ready to go! I'll put it to the test next week when I go fishing!
-PJ
PS- Looks like you got the measurements for the ATD 50W as well, awesome Bud! ATD 80 and 80w next? ;)
I just did a TLD20II. I should have measured it. Sorry.
I would be interested in a TLD 50 sleeve if you ever have the chance.
Conchydog,
The TLD 30 II and I believe the larger TLDS will benefit from the sleeving. What this does is allows you too remove the 2 'C' clips on the shaft and allow the the shaft to float independent of the bearing spacing. You can now play with the belleville stacks and not have to worry about shim spacing and you eliminate the thrust drag on the clicker gear/retainer on the end of the spool.
I do have the 10mm tubing in stock. If your shaft is 9mm and you can get a accurate measurement I can make a sleeve. You may have to tweak it a bit but the free spool is good enough you could consider pitching baits with it.
Any one have the TLD 50 bearing spacing???
Thanks,
Jim N.