Print Page - 130 clamp measurement

Title: 130 clamp measurement
Post by: thorhammer on December 12, 2017, 02:32:15 AM

Need center-to-center measurement of 130 Int clamp studs, or positive ID that a 130 clamp fits a 16/0.

thanks,

John

Title: Re: 130 clamp measurement
Post by: UKChris on December 31, 2017, 11:34:11 AM

Hi John,
Don't know if you've found out elsewhere yet but I've just seen this request.
I don't have a 16/0 (or a 14/0) but I do have a couple of 130ST and a couple of 12/0 Senator.

The centre-to-centre distance for the 130ST is 6cm or 2 ⅜ inches. It is the same distance for the 12/0.
The saddle clamps for each fit the other perfectly.

You can determine whether a 16/0 is the same by checking the reel saddle part number; for the 12/0 it is 55-116. I have a parts catalogue around somewhere...

Cheers,
Chris

Title: Re: 130 clamp measurement
Post by: thorhammer on December 31, 2017, 12:07:44 PM

Thanks Chris! i was hoping to go with a Strike master clamp for a 130, but it is too short for 118 by a quarter inch. I have to either go stock or make one.

Title: Re: 130 clamp measurement
Post by: Bill B on January 01, 2018, 04:54:28 AM

I vote....Make One.....we all want to see it happen... ;D Bill

Title: Re: 130 clamp measurement
Post by: thorhammer on January 02, 2018, 08:39:10 PM

Bill, its single digits here. it will cost more in propane to heat the shop than the clamp is worth lol! I'll get to it though, just got to warm up enough to get to the drill press. I'm not filing that much aluminum. Mike and Chris can have my files down there where it's summer.

Reel Repair by Alan Tani

Conventional and Bait Casting Reel Rebuild Tutorials and Questions => Penn International Tutorials and Questions => Topic started by: thorhammer on December 12, 2017, 02:32:15 AM