Making shims? .. how do you do it exactly, Thanks Joe.
Buy several sizes of shim stock (brass or stainless) and cut them out with scissors or shears or punch.
-steve
Thank you.
Brass shim you can drill with a good sharp drill bit, then cut the outside diameter with a scissors. I just did 2 a few days ago. A dull drill bit causes a burr and it is difficult to get nice and straight edge from that.
Quote from: basenjib123 on April 05, 2020, 02:27:27 AM
Making shims? .. how do you do it exactly, Thanks Joe.
I call McMaster-Carr.
Best, Fred