Just wondering if anyone has or is using 321 on older spinning reel pinion bearings instead of grease, etc.? Thanks, Joe.
I've been putting TSI-321 on all my 1st & 2nd generation Penn Spinfisher bearings and it works fine. It was terrible on a Mitchel 308 --that bearing worked much better packed with grease.
I use it on all my spinners, conventionals, fly reels, pliers, cutters, guns - I basically use it on everything even if it doesn't move :D
If you are going to cast with the reel, I think TS321 would be fine on a pinion bearing.
I just used it on 0000 steel wool to treat the barrel on my 1950 something shotgun. The gun hasn't looked that good since I used it in Nebraska some time around 1979.
Thanks for the replies..