Hi Folks,
First post here. Great site and resource. I wanted to contribute some info that was learned this past week trying to order drag washers for my 'backup' electric assist reels.
I have 2 reels that were purchased in the US. And 2 backup reels that were purchased off ebay from Japan.
One of the Japanese Tanacom 750 Bulls the drag washers were sticky. So they were a good candidate for replacement.
That being said, the SIZE of the drag washers are indeed different between the US 750 and the Japanese one.
I measured them with a caliper and thought I'd post / share so you have this for reference in case you ever are in the same situation.
Here is what I got. This is the 'old' / original drag washers that are in the Japanese version of the reel.
Inner/Red drag washer:
.022" thick -> .56mm
.783" OD -> 19.88mm
.320" ID -> 8.1mm
Outer drag washers (5 of them):
.032" thick -> .812mm
.737" OD -> 18.7mm
.363" ID -> 9.22mm
Comparing that with some Smoothdrag Carbontex that I ordered for a US 750 and these measured the following:
Inner:
.018" thick -> .45mm
.808" OD -> 20.5mm
.320" ID -> 8.128mm
Outer washers (5 of them):
.030" thick -> .762mm
.852" OD -> 21.64mm
.410" ID -> 10.414mm
At any rate, hope this is helpful and hopefully I put it in the right spot on the forum.
:)
-J