Hey guys,
I was wondering if someone could tell me if there is a difference between the P-series and S-series jack assemblies. I mean, do they have different size threaded holes? Are the shaft sizes different? Can they be swapped from one model to another?
I was considering buying P-series side plates for a Tiburon build I'll be doing with an S344 but not if it would require more than just a straight swap of internals(except for the bearing cups. I know they are different).
Thanks,
Chris
The levers are pretty much the same dimensions on all 300 size except the blackies,the S has a plastic end, the P is stainless. Should be a strait swap with the side plates, except the bearings. Might take some fine tuning with shims here and there to get it perfect