hi guys,
just another quick newby question.
i have been doing a fair bit of tinkering and am now confident in dissassembling and reassembling my small baitcasters.
my question is, how do give the reels a good going over in terms of cleaning and re-lubricating, do i need to go any further than what is pictured? i was thinking a light brush with a tooth brush with some degreaser and a good air dry?
and if not, how do i go about cleaning the grease from what is pictured?
cheers
the reel is a daiwa alphas r-edition btw
G'day nagz, everyone will have their own take, but I use a toothbrush and a bit of white spirit to clean off old grease etc, then dry and wipe down thoroughly with a clean rag.
I always completely disassemble all component parts, as those last few can conceal grit, corrosion etc.
Also, the bearings under the handle shaft and clutch plate can't be accessed without a full strip down.
Hope that's of some assistance.
Cheers, Justin
cheers redsetta,
guess i have some more tinkering to do. i pulled out the top spring in the pic, man was it hard to get back in there without pliers lol
white spirit and a toothbrush sounds easy enough though
thanks very much mate
see the bearing in the center? that has to be pulled, carefully packed with grease and reinstalled. there might also be a bearing under the drive shaft. you have to remove it to pack the pinion support bearing anyway. yeah, it all has to come out...... :-\
thanks alan.
i was kinda hoping i could cut some corners :) a bad habit to fall into lol